- Conveyor Belt
- Conveyor Idler
- Conveyor Pulley
- Conveyor Bracket Frame
Cold-resistant Conveyor Belt For Cold Place
Cold-resistant conveyor belt for cold place:Width from 10mm to 3000mm,Flat rubber cover and used to -40cChat Now
Cold-resistant conveyor belt for cold place:
Width from 10mm to 3000mm
Flat rubber cover and used to -40c
Conveyor belt connector method:
All conveyor belts must be connected in a ring to be used. Therefore, the quality of the conveyor belt joints will directly affect the service life of the conveyor belt and the smooth and smooth operation of the conveyor belt. The common methods of conveyor belt joints are mechanical joints, cold joints, and hot vulcanized joints.
Nylon conveyor belt maintenance and maintenance
1. During transportation and storage, the conveyor belt should be kept clean from direct sunlight or rain and snow and prevent contact with acids, alkalis, oils, organic solvents, etc., and should be located one meter away from the heating device.
2. The storage temperature should be kept between 18-40 °C during storage, and the relative humidity should be kept between 50-80 %.
3. During the storage period, the product shall be placed in a roll and shall not be folded. It shall be turned once every quarter during storage.
4. The conveyor belts of different types and specifications should not be used together, and the joints are preferably glued.
5. The type, structure, specifications and layers of conveyor belts should be selected according to the conditions of use.
6, the conveyor belt running speed should generally not be greater than 2.5 meters / second, block size, large wear materials and the use of fixed pear unloading device should try to use low speed.
7. The relationship between the diameter of the conveyor roller and the conveyor belt layer, the matching of the driving roller and the reversing roller, and the requirements for the slot angle of the roller should be reasonably selected according to the design rules of the conveyor.
8. Feeding direction should follow the running direction of the tape. In order to reduce the impact of the material falling on the tape, chute should be taken to reduce the material dropping distance; the tape receiving section should shorten the idler spacing and use the buffer idler as leakage material. The belt conforms to a soft and moderate baffle plate to prevent the stock plate from being too hard and scratching the belt surface of the conveyor belt.
9. Conveyor belts should pay attention to the following matters in use: 1 Avoid the idler being covered with material, causing rotation failure, preventing the leakage of material stuck between the roller and the tape, paying attention to the lubrication of the moving part, but not conveying the tape with oil; 2 Avoiding With load to start; 3 deviation occurred tape, take measures to correct the application; 4 found that local damage to the tape when the application of artificial cotton repair, so as not to expand;