Home > News > Content
How To Properly Install The Conveyor Pulley
Jun 20, 2017

How to properly install the Conveyor Pulley
Some engines use flat-shaped fan belts that should be checked for belt and Conveyor Pulleys when mounted on Conveyor Pulleys. Flat belt should be in good condition with the Conveyor Pulley, otherwise the belt life will not be long. Some models are used on the V-belt, the wrong phenomenon, it should be promptly corrected. Phenomenon: abnormal operation when the engine noise, such as rustling, squeaky, rushing sound, etc., in the engine to stop running when you can move the belt to move the belt, check whether there is a large amount of open, if you find a large gap should be replaced belt Media wheel.

    In the case of not timely replacement of the case, sometimes the amount of large wheel swing caused by the belt to accelerate wear and tear, sometimes the belt of the furnace tube stuck to the belt polished, and sometimes Conveyor Pulley itself off, so that the belt groove, the engine generators and pumps, Steering power pumps, air conditioning pumps and other components that require engine power to lose power sources cause the vehicle to break down and can not run normally.

    Conveyor Pulley In the car engine between 60,000 to 90,000 km, we should check the belt wear situation, but also pay attention to check the work of the engine belt media. If there is an abnormality should be replaced, even if the belt wear is not serious, replace the engine belt. Belt daily inspection method

    The belt inspection mainly includes two aspects: belt tension and belt wear.

    Conveyor Pulley First check the tension of the belt, then you can use the thumb, press the two pulleys in the middle of the belt. Press the pressure of about 10kg or so, if the belt pressure in the 10mm or so, that the belt tension to play appropriate. If the pressure is too large, the tension of the belt is considered insufficient. If the belt is hardly pressed down, the tension of the belt is considered too large. When the tension is insufficient, the belt is prone to slip. Tension is too large, it is easy to damage a variety of auxiliary bearings. For this reason, the relevant adjustment nut or bolt should be loosened and the tension of the belt should be adjusted to the best condition.

    Conveyor Pulley In addition, we must pay attention to the wear of the belt. The old belt wears serious, so that the belt and conveyor belt contact area dropped. At this time as long as the pressure of a pressure belt, the belt deep sink to the conveyor belt pulley. Belt rubber also has an aging problem, if the belt rubber serious aging, must be replaced in time for the new belt.

    There are several belts in the front of the engine, each belt is playing an important role. In the engine, through the belt drive a variety of auxiliary machine operation, such as air conditioner compressor, power steering pump, alternator and so on. If the belt is broken, or there is a slip, will cause the auxiliary auxiliary function loss, or make its performance down, thus affecting the normal use of the car. Therefore, the daily inspection of the belt is very important.